Seminal
The magazine and atlas of EU-funded researchA new publication from the web and AI team at Scott Charnley

Atlas / Denmark

Marie Skłodowska-Curie Action · Running

AMacSurface Experimental and numerical studies for evaluation of surface integrity in post-processing of additively manufactured nickel-based alloy by machining process

Coordinator
Syddansk Universitet, Denmark
Runs
1 October 2025 to 30 September 2027
Status
Running
EU funding
€263k
Total cost
—
Partners
2 organisations in 2 countries
Type
Marie Skłodowska-Curie Action
Grant agreement
101198826

What the project is doing

In the project's own words, from its summary on CORDIS.

As a new technology, Additive Manufacturing (AM) provides an excellent opportunity to produce parts with complex geometry that would not be possible with traditional manufacturing methods. Against several advantages of AM technology, surface quality of an AM-built part might not be suitable for many applications. To solve this issue, one must use post-processing by machining process to obtain a suitable surface quality and dimensional accuracy of parts produced by AM.

Regarding the machining processes, the desirable surface integrity of the machined components is one of the dominant requirements of the industries because it significantly affects the performance and service life of the final products. Inconel 718 alloy, as a difficult-to-cut material, has excellent properties. Not only few experimental studies are found in literature on machining of AM Inconel 718 alloy, but also, they have mostly limited to Conventional Machining (CM) processes.

In addition, very few studies are found in literature on machining simulation of this new material due to absence of reliable material model for modeling the chip formation. To address this gap and aiming to push the fundamental science behind this problem, the main goal of the present project is to comprehensively evaluate the surface integrity condition after machining of AM Inconel 718. Firstly, the correlation between main AM parameters and machining characteristics are investigated.

Then, a comparative experimental study will be conducted on CM, Cryogenic Cooling Machining (CCM) and Laser-Assisted Machining (LAM) to obtain desirable surface integrity after machining of AM Inconel 718 alloy. After that, fundamental advances for machining simulation of AM Inconel 718 will be presented. Based on this, identification of the new and reliable material model for machining simulation, innovative methods for predicting the surface integrity including microstructure changes and residual stress will be addressed at this project.

Topics

Who is involved

OrganisationCityCountryRole
Syddansk UniversitetOdense MDenmarkCoordinator
Hochschule FurtwangenFurtwangenGermanyAssociatedpartner

Source: CORDIS, European Commission. Data of 5 Nov 2026, reused under the Commission's reuse policy. View on CORDIS · Grant DOI